ENTERPRISE JEWELRY SOFTWARE LICENSE AGREEMENT

Please read the EJS license agreement (shown below) carefully before purchasing.

This is a legal agreement between Innovez One Pte Ltd (Singapore Business Number 200411033W) and you the user. Innovez One Pte Ltd shall be referred to as Innovez from here on in. When you download this software you are agreeing to accept the terms of this Agreement. This Agreement is a legal contract, which specifies the terms of the license and warranty limitation between you and 'Innovez'. You should carefully read the following terms and conditions before installing or using this software. It applies only to Enterprise Jewelry Software. If you do not agree to these terms and conditions then you may not install or use the Enterprise Jewelry Software. 1. License, Ownership and Use. The Enterprise Jewelry Software is licensed and not sold. It and its accompanying files and/or documents are owned and copyrighted by Innovez. Innovez grants the user a perpetual non-exclusive non-transferable license to use the Enterprise Jewelry Software on one computer. The Enterprise Jewelry Software is considered in use on a computer when it is loaded into temporary memory or installed into permanent memory. If you wish to use the software on more than one computer then you must purchase additional licenses. If you have purchased a Enterprise Jewelry Software Server Edition license then you may use the software on the number of computers at the one physical location as allowed in the Enterprise Jewelry Software Server Edition license. One physical location means one building or contiguous group of buildings. You may not reverse engineer, disassemble, decompile or alter this software in any way except to the extent that the foregoing restriction is expressly prohibited by applicable law. 2. Copying and Distribution. You may NOT reproduce and/or distribute copies of the Enterprise Jewelry Software distribution files or any of their constituent or associated files or materials to third parties. You may make copies for internal backup purposes. 3. Warranty Disclaimer and Limitation of Liability The Enterprise Jewelry Software is licensed to the user on an "AS IS" basis. Innovez MAKES NO WARRANTIES, EITHER EXPRESS OR IMPLIED, WITH RESPECT TO THIS Enterprise Jewelry Software AND ITS ASSOCIATED FILES AND DOCUMENTS INCLUDING BUT NOT LIMITED TO ANY WARRANTY OF MERCHANTABILITY OR FITNESS FOR ANY PARTICULAR PURPOSE. BECAUSE OF THE VARIOUS HARDWARE AND SOFTWARE ENVIRONMENTS INTO WHICH ENTERPRISE JEWELRY SOFTWARE MAY BE USED, NO WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE IS OFFERED. Innovez DOES NOT WARRANT THAT THE OPERATION OF THE SOFTWARE WILL BE UNINTERRUPTED OR ERROR-FREE, OR THAT DEFECTS IN THE SOFTWARE WILL BE CORRECTED. You the user are solely responsible for determining the appropriateness of the software for your use and accept full responsibility for all risks associated with its use. Innovez is not and will not be liable for any direct, indirect, special or incidental damages (including loss of profits or interruption of business) however caused even if Innovez has been advised of the possibility of such damages. 4. Severability. If any provision of this Agreement is held to be unlawful or unenforceable, or otherwise invalid, this Agreement will remain in effect with the invalid provisions omitted, unless omission would frustrate the intent of the parties, in which case this Agreement will immediately terminate. 5. Complete Agreement. This Agreement is the entire agreement between you and Innovez relating to its subject matter. It supersedes all prior or contemporaneous oral or written communications, proposals, conditions, representations and warranties and prevails over any conflicting or additional terms of any quote, order, acknowledgment, or other communication between the parties relating to its subject matter during the term of this Agreement. No modification to this Agreement will be binding, unless in writing and signed by an authorized representative of each party. Any action related to this Agreement will be governed by the laws of the Republic of Singapore.